IHealth Clear BPM1 - Wireless Blood Pressure Monitor Quick Start

Measurement

Fully charge the blood pressure monitor before first use.

1. Rest your bare (or thinly clothed) left arm flat on a table.
   
2. Place cuff over left arm so the cuff tubing is centered on the inside of your arm and aligned with your middle finger.
   
   Note the direction of the cuff tubing and alignment with your middle finger.
3. The bottom of the cuff should be about 1/2" above your elbow. Tighten the cuff firmly, leaving about 1 finger space.
   
4. Insert cuff tubing connector into blood pressure monitor unit, and the monitor will power on automatically.
   
   Make sure to fully insert the cuff tubing connector into the blood pressure monitor.
5. You will need to select your language after turning on the monitor for the first time.
   
6. Press User 1 or User 2 button again to start a measurement. Press any button to stop a measurement and to turn off the monitor.
   
   During the measurement, you will feel the cuff tightening around your arm. Remain still and do not move your arm until the measurement is complete.

Wireless Network Setup

1. Go to the Apple App Store or Google Play Store and search "iHealth MyVitals." Download the app and then log in.
   

2. Press and hold the User 2 button for 10 seconds until the screen displays the select language page
   
3. The screen will display the wireless network setup page. Launch the iHealth MyVitals app, go to Select New Devices and choose Clear (BPM1). Follow the on-screen instructions to finish setting up your wireless network.
   

Setup complete! Your blood pressure measurements will automatically upload to the iHealth MyVitals app.

Documents / Resources

References

• App Store - Apple
• Google Play

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download IHealth Clear BPM1 - Wireless Blood Pressure Monitor Quick Start