Advertisement
STEP 2:
(SEE FIGURE 3)
*
Remove tractor hood. (Refer to tractor manual.)
*
Remove the browning shield as shown.
REMOVE
FRONT SCREWS
REMOVE
BROWNING SHIELD
FIGURE
3
STEP 3:
(SEE FIGURE 4)
*
Place plug on a work bench or solid table and push
end of bumper down onto plug. Repeat for all plugs.
BUMPER
-._
PUSH DOWN
WiTH EVEN
PRESSURE
WORK BENCH
OR SOLID TABLE
STEP 4:
(SEE FIGURE 5)
*
Insert a carriage bolt into the second mounting hole
from the front of the tractor frame and fully tighten a
whizlock nut onto the bolt. Repeat on other side of
tractor.
CARRIAGE BOLT
AND WASHER
\
WHIZLOCK
NUT
FIGURE 5
STEP 5:
(SEE FIGURE 6)
*
Spread ends of bumper enough to fit slots onto bolts
in rear mounting holes in tractor frame.
*
The bumper has three mounting holes. The rear
hole provides the most clearance while the forward
holes provide a neater appearance. Use a hole
that provides enough clearance for hood to stay in
raised position when opened. Insert a carriage bolt
and washer through tractor frame and into desired
mounting hole on each side of bumper and secure
with a whizlock nut.
IMPORTANT:
Before fully tightening nuts, be sure
tractor hood will stay in raised position when opened.
CARRIAGE
BOLT
AND WASHER
FIGURE 6
4
Call 1-866-576-8388
for missing parts or assembly help
DO NOT RETURN TO STORE
Advertisement
