Code 7F.; Sub Char From; Ptx Sfcc - TallyGenicom T6212 Operator's Manual

Chapter 3: Printer Menus and Configuring Your Printer
This parameter allows you to dictate how the printer will react when it receives
a Hexadecimal code 7F. The default value depends on the emulation. (See
the Emulation Parameter, presented earlier in this chapter.)
Ignore:
Delete Char: The previous character is deleted.
Delete Buffer: The previous characters on the current print line are
Space:
Fill:
This parameter defines whether locations 80 through 9F Hex are to be treated
as control characters or printable characters. The function of the control
characters in this area depends on the emulation. The selections are ON
(printable characters) or OFF (control characters). The default value is ON.
This parameter allows you to select a character that will be ignored in the
incoming data stream. This parameter functions in all emulations and non-
downloadable print modes. It does not function in plot mode, font download,
or VFU download. Selections are 0-255, referring to the decimal value of any
8-bit character, or OFF. Default is OFF.
This parameter allows you to select a character that will be replaced by the
character designated by the Sub Char To parameter. This parameter functions
in all emulations and non-downloadable print modes. It does not function in
plot mode, font download, or VFU download. Default is OFF.
This parameter allows you to select the character that will replace the character
designated by the Sub Char From Parameter. This parameter functions in all
emulations and non-downloadable print modes. It does not function in plot
mode, font download, or VFU download. Default is OFF.
Defines the Special Function Control Character used by the Printronix P5000
emulation. The decimal value of the ASCII character code is entered. The
default value is 1 (SOH).
Defines the single line Alternate Line Spacing used by the ACK (Hex 06) com-
mand in the Printronix P5000 emulation. The possible selections are 8 or 10.3
which define the line density. The default value is 8.
The PTX SFCC and PTX ALS options will only appear if the Printronix
P5000 emulation is selected with the Ser/Par Emul control panel option.
The code is ignored.
deleted.
A Space character is substituted.
A Fill character is substituted.
3–21