Bosch REXROTH HYDROTRAC GFT 8000 Operating Instructions Manual page 34

34/70 Assembly
Procedure
Bosch Rexroth AG, General Operating Instructions HYDROTRAC GFT 8000 series 40, RE 79022-01-B/04.2020
11 Attach the planetary gearbox to the machine or chassis frame. For the required
strength class of the mounting screws as well as the necessary tightening
torques is the machine or vehicle manufacturer liable. The required mounting
screws are not included within the scope of supply.
12 Remove all means of attachment, transport and lifting equipment.
13 Remove the dust cap 18 and the thrust cup.
Installing the axial-piston motor to the planetary gearbox:
Failure or damage to the planetary gearbox
An O-ring forgotten during assembly or installed improperly may cause leakage or
failure of the planetary gearbox!
Observe correct O-ring size depending on the O-ring groove of the axial-piston

motor.
Ensure that the O-ring is installed correctly in the corresponding O-ring groove

of the axial-piston motor.
If Rexroth delivers the hydrostatic drive without axial-piston motor, the
operating instructions of the motor are not included in the scope of supply.
Observe the operating instructions of the axial-piston motor (provided by the
manufacturer of the axial-piston motor). This is where you will find all the
required information on assembly and commissioning of the axial-piston motor.
CAUTION