How To Use - Braun PL3000 Manual

Do not touch the glass filter during or directly after use since it will get hot.
Do not use petroleum-based or flammable cleaning agents (alcohol, acetones) on
the device as these pose a fire risk.
Do not use abrasive cleaning agents. These may damage the device or scratch the
glass filter.
Do not attempt to use this device other than for removing unwanted hair.
Do not use the device on a surface other than skin. Do not press the treatment
button when the treatment window (1) is not placed in full contact with the skin.
Do not block the cooling vents. The device may overheat and pose an electric
shock risk or fire hazard.
Do not override the safety mechanism inherent to the device.

How to use

Preparing the treatment area
Remove any visible hair on the skin before using the device. You may use your preferred hair removal
method. To keep the treatment window clean and prevent hair burns, ensure there is no hair remaining on
the skin surface. Clean the treatment area and pat it dry.
To power on the device:
Use the mains cord (8) to connect the base station to an electrical outlet. Press any button ( 4 or 5) to
activate the device. The LED power bars (3) will light up once and, a fan starts running. This means the
device is in READY mode. During operation, the device will heat up slightly.
Automatic light adaptation
When both skin tone sensors (2) have skin contact, the device reads your skin tone and selects the
appropriate light intensity which is indicated by white LEDs on the Power bars (3). These confirm that the
device is ready to flash.
Sensitive mode
Push the sensitive mode button (4) to reduce light intensity. The sensitive mode indicator lights up when it
is activated. To deacticate it, press the sensitive mode button again.
The power bars flash to confirm a change in the light intensity setting.
When holding the sensitive mode button (4) longer than 3 seconds, the device is deactivated.
After 10 minutes without use, the device is automatically deactivated.
Press any button to reactivate it.
Patch Test
Before your first treatment, we recommend you test your skin for reaction to Braun Silk·expert on a small
area of skin of the body part you plan to treat (about 2 x 3 cm in size; equivalent to the size of two flashes,
side by side).
light skin tone U high light intensity
dark skin tone U low light intensity
no LEDs
no skin contact U device will not flash
red LED invalid skin tone U device will not flash
7