Craftsman 358.792443 Operator's Manual page 5

CARTON CONTENTS
Check carton c ontents against the fol- Coupler
lowing list. LOOSEN
Model 358.792443
• Brushcutter attachment
• Handlebar
• Handlebar mounting bracket for1"
(2.5 cm) s haft
• Handlebar mounting bracket for7/8" TIGHTEi', Knob
(2.2 cm) s haft
• Bracket cover (2)
• Shoulder strap
• Upper shoulder strap c lamp
• Lower shoulder strap c lamp ( with
spacer tabs)
• Handlebar bracket screws (4)
• Shoulder strap c lamp screws (2)
• 4-point weed b lade ( assembled on
brushcutter attachment)
• Large n ut f orinstalling blade
• Retaining washer
• Cupped washer
• Metal shield ( assembled onbrush-
cutter attachment)
• Trimmer head
• Plastic shield
• Wing n ut ( screwed onto plastic shield)
• Attachment Hanger Locking/
• Hex Wrench UpperRelease Attachment
• Container ofline Shaft Button
Examine parts f ordamage. Donot u se
damaged parts.
NOTE: Ifyouneed assistance orfind
that p arts a remissing ordamaged, call
1-800-235-5878.
ASSEMBLY
_i WARNING: Ifreceived assembled,
repeat all s teps toensure your unit i s
properly assembled and all f asteners
are secure.
2. Remove the shaft cap from the
brushcutter attachment (ifpresent).
3. Position locking/release button of
attachment into guide recess of
coupler.
4. Push t heattachment into the cou-
pler u ntil the locking/release button
snaps i nto theprimary hole.
5. Before using t he unit, tighten the
knob s ecurely by turning clock-
wise.
Coupler Primary Hole
Guide Recess
,_ WARNING: Make sure the lock-
ing/release button is locked in the pri-
mary hole and the knob is securely
tightened before operating the unit. Us-
ing the wrong hole could lead to serious
injury or damage to the unit.
• A hex wrench (provided) is required'_
for assembly.
INSTALLING BRUSHCUTTER AT-
TACHMENT
CAUTION: When removing or instal-
ling attachments, place the unit on a
flat surface for stability. Locking/Release
1. Loosen the coupler by turning the Button in Primary Hole
knob counterclockwise.