Baofeng UV-5G PLUS User Manual page 38

PTT-LT
23 - Signal code sending
delay
MDF-A
24 - Channel Mode A
Display
MDF-B
25 - Channel Mode B
Display
BCL
26 - Busy Channel
Lock-out
AUTOLK – Automatic
27
Keypad Lock
SFT-D
28 - Frequency Shift
Direction
OFFSET - Frequency
29
shift amount
MEMCH - Store a
30
Memory Channel
the beginning and ending
0[0] 100[1] 200[2] 400[3]
600[4] 800[5] 1000[6]
CH [0]: Displays the channel number
•
NAME [1]: Displays the channel name.
•
FREQ [2]: Displays programmed Frequency
•
CH [0]: Displays the channel number
•
NAME [1]: Displays the channel name.
•
FREQ [2]: Displays programmed Frequency
•
OFF [0] | ON [1]
OFF [0] | 5 [1] | 10 [2] | 15 [3]
OFF [0]: TX = RX (simplex)
•
+ [1]: TX will be shifted higher in frequency
•
than RX
- [2]: TX will be shifted lower in frequency
•
than RX
00.000 - 69.990 in 10 kHz steps
001 - 999
38
PTT-ID Delay (milliseconds)
[A] MR/Channel Mode Display Format
Note: Names must be entered using software.
[B] MR/Channel Mode Display Format
Note: Names must be entered using software.
Disables the [PTT] key on a channel that is
already in use. The transceiver will sound a beep
tone and will not transmit if the [PTT] key is
pressed when a channel is already in use.
Set the automatic keyboard lock delay time. To
prevent the keyboard from being accidentally
triggered.
When turned on, if the keyboard is not used
within a predetermined delay time, the keyboard
will be locked. Pressing the
seconds will unlock the keypad.
Enables access of repeaters in VFO/Frequency
Mode
Specifies the difference between the TX and RX
frequencies
This menu is used to either create new or modify
existing channels (001 through 999) so that they
can be accessed from MR/Channel Mode.
key for 2