Baofeng UV-5G PLUS User Manual page 37

16 CDCSS SAVE MODE
VOICE
17
- Voice Prompt
LANGUAGE
18
- Language selection
DTMFST
19
- DTMFST
S-CODE
20
- Signal Code
SC-REV
21 - Scanner
Resume Method
PTT-ID
22 - When to send the
PTT-ID
ALL[0] RX[1]|TX[2]
OFF [0] | ON [1]
ENGLISH [0] |
OFF [0]: No DTMF Side Tones are heard
•
DT-ST [1]: Side Tones are heard only from
•
manually keyed DTMF codes
ANI-ST [2]: Side Tones are heard only from
•
automatically keyed DTMF codes
DT+ANI [3]: All DTMF Side Tones are heard
•
1[0] | 2[1] | 3[2] | 4[3] | 5[4] | 6[5] | 7[6] |
8[9] | 9[8] | 10[9] | 11[10] | 12[11] | 13[12]
| 14[13] | 15[14]
TO [0]: Time Operation - scanning will
•
resume after a fixed time has passed
CO [1]: Carrier Operation - scanning will
•
resume after the signal disappears
SE [2]: Search Operation - scanning will not
•
resume
OFF [0]: No ID is sent
•
BOT [1]: The selected S-CODE is sent at the
•
beginning
EOT [2]: The selected S-CODE is sent at the
•
ending
BOTH [3]: The selected S-CODE is sent at
•
37
Save the scanned CTCSS/DCS in VFO mode.
ALL: Save to R-CDCSS and T-CDCSS
•
TX: Save to T-CDCSS only
•
RX: Save to R-CDCSS only
•
Allows audible voice confirmation of a key press
Set the language type of menu and prompt
voice.
ENGLISH: Display as an English menu with
•
[1]
English prompts for operation.
Chinese: Display as a Chinese menu and
•
prompt for operation in Chinese.
Determines when DTMF Side Tones can be
heard from the transceiver speaker.
Selects 1 of 15 DTMF codes. The DTMF codes are
programmed with software and are up to 5 digits
each.
Scanning Resume Method
When to Send PTT-ID Codes are sent during
either the beginning or ending of a transmission.