Toshiba TD-P493 Owner's Manual page 26

Connecting to the Display LAN port
Download and install the PuTTY software from the
following link first: http://www.putty.org/.
Run the software and enter the Display's IP address in
the field Host Name. Enter "1986" as a default value
in the field Port. Then select "Telnet" as Connection
type and click the Open button.
Note: Refer to the Connectivity section of this manual for
information on connecting the Display to a network and
displaying the IP address of the Display.
Use the commands in the RS232 Command Table
which can be found on Toshiba website.For
example, if "GETVOLUME" command is entered,
current volume level should be displayed on the putty
window as shown in the pictures below.
Another example;
Volume level can be changed by using "VOLUME"
command. After sending this command, you can verify
the changes from the Display.
The last example ;
When "GETSOURCE" command is entered, current
source should be displayed on the putty window as
shown in the picture below.
Connecting to the Display (RS232 port)
Run the software and select Serial as Connection
Type. Enter the Display's serial port in the field
Serial Line (in the following example it is COM4)
and "115200" in the field Speed. Then click the
Open button.
English - 25 -