Sitecom WLR-9000 User Manual page 30

When you select 64-bit or 128-bit WEP key, you have to enter WEP keys to encrypt data. You can
generate the key by yourself and enter it. You can enter four WEP keys and select one of them
as a default key. Then the router can receive any packets encrypted by one of the four keys.
•
Key Length: You can select the WEP key length for encryption, 64-bit or 128-bit. The
larger the key will be the higher level of security is used, but the throughput will be
lower.
•
Key Type: You may select ASCII Characters (alphanumeric format) or Hexadecimal
Digits (in the "A-F", "a-f" and "0-9" range) to be the WEP Key.
•
Key1 - Key4: The WEP keys are used to encrypt data transmitted in the wireless
network. Use the following rules to setup a WEP key on the device. 64-bit WEP: input
10-digits Hex values (in the "A-F", "a-f" and "0-9" range) or 5-digit ASCII character as
the encryption keys. 128-bit WEP: input 26-digit Hex values (in the "A-F", "a-f" and "0-
9" range) or 13-digit ASCII characters as the encryption keys.
Click Apply at the bottom of the screen to save the above configuration.
WPA Pre-shared Key