Setting up and connecting
Electrical connections
IMPORTANT
►
Before you connect up, compare the connection data (voltage and fre-
quency) on the plate of the appliance with that of your electrical network.
This data must match in order to avoid damage to the appliance.
►
Check to ensure that the power cable
and it will not be laid over hot surfaces and/or sharp edges.
►
Make sure that the power cable
►
Do not let the power cable
Inserting batteries into the remote control
s
To insert a new battery, proceed as follows:
♦
Open the battery compartment at the rear of the remote control
rotating the circular cover in the direction of the symbol
coin for turning it.
♦
Insert a battery of the type CR 2032 (3V) into the battery compartment.
Make sure the polarities are correct; the positive pole faces up.
♦
Close the battery compartment by replacing the round cover and turning it
in the direction of the symbol
Fixing the air-bubble mat into the bath
DANGER
Slippery!
If the air bubble mat is not fi xed into the bathtub properly,
there is a great risk of slipping!
Observe the following safety information to avoid the risks of slipping:
►
Carefully press the air-bubble mat onto the bottom of the bath tub until all
of the suction cups on the air-bubble mat are fi rmly secured to the bath
bottom.
►
Check every time before getting into the bath tub whether the air-bubble
mat is still properly and fi rmly secured.
►
Do not climb into the bathtub before all the suction cups of the air-bubble
mat are properly secured in the bath tub.
SLB 450 A2
of the appliance is undamaged
4
is not over taut or folded.
4
hang over edges (trip wire eff ect).
4
until it is fi rmly seated back in the housing.
9
by
. Use a small
69
GB
MT