Table of Contents
Advertisement
5. PRODUCT INSTALLATION
Important notes and advice:
- If you test your product before installing it, ensure that you do not test it with the intercom panel
and the monitor in the same room or the videophone may emit a shrill noise (feedback).
- Do not expose the camera lens to direct sunlight or a reflective surface.
- We recommend running the cables through a protective sheath to protect them against breakage
and bad weather.
5.1 Wiring
In order to avoid the risk of interference and malfunction, do not pass the wire for your videophone
through the same sheath as the electrical wires.
Warning:
Do not under any circumstances double wires to increase the wire size.
a. Connecting the videophone (monitor, intercom panel and camera, see fig. 1, fig. 2 or fig. 3)
Wires to be used: 2 wires 0.75 mm
up to 80 m long or 2 wires 1.5 mm
up to 120 m long.
2
2
- Be sure to connect the wires in accordance with the wiring diagram.
- Be sure to refer to the labelling on the back of the monitor and the back of the intercom panel.
b. Connecting an electric strike plate or lock
Important:
The electric strike plate or lock that you install must be equipped with a mechanical
memory. The strike plate current cannot exceed 1.1A.
- Connect it directly to terminals 5 and 6 at the back of the intercom panel (no need to observe
polarity).
- The opening function is only possible if the video from the respective intercom panel is displayed.
c. Connecting a gate motor
- The intercom provides a dry contact (without power) to be connected to the push button control
of the automatic opener.
- Connect it directly to terminals 3 and 4 at the back of the intercom panel (no need to observe
polarity).
- The opening function is only possible if the video from the respective intercom panel is displayed.
5.2 Configuring the intercom (see Fig. 1)
a. Intercom volume settings:
Turn the volume control with a Phillips head screwdriver to adjust the intercom volume.
5
Philips - Lite - V1
Advertisement
Table of Contents
