Installation Step - Viessmann Vitopure S4-RO-400G Pro Installation And Service Manual

Installation Step

S4-RO-400G Pro
1. Turn Off the Water Main Valve
2. Install the Three-Way Ball Valve
■ Select the location of installing the three-way ball valve on the water supply pipeline.
■ Wrap the water stop around the outer teeth of the three-way ball valve.
■ The outer teeth of the three-way ball valve are connected with the water point pipeline and screwed tightly, otherwise it will
cause water leakage.
■ The three-way ball valve hitch is connected to the water supply pipeline and screwed tightly. There is a water stop pad in the
hitch, so please don't lose it. The water stop pad should be placed flat in the union. Otherwise it will cause water leakage.
3. Install Faucet
The faucet accessories package includes: Faucet body, LED ring seat, sealing ring, fixed steel sheet, fixed rubber pad, limit nut,
fixed nut and PE water pipe quick connector. Select the installation position of the faucet.
■ If there is a soap dispenser hole in the stainless steel basin, the soap dispenser hole can be used as the installation hole of
the water purification dragon. If there is no soap dispenser hole in the stainless steel basin, please use a hole opener with a
diameter of not less than 30mm in the selected position.
■ If it is an artificial stone or marble basin, please select the opening position on the countertop.
■ Use a hole opener with a diameter not less than 30mm to open the hole.
■ Drill mounting holes in the mounting position on the table top.
■ Install the sealing ring under the faucet LED ring seat.
■ Insert the screw rod of the faucet into the installation hole.
■ A fixed rubber pad, a fixed steel sheet, a limit nut and a fixed nut are sleeved on the screw rod passing through the table in
sequence, and are tightened and fixed by a wrench.
■ Insert PE water pipe quick connector into the screw rod of faucet.
4. Connection Between Three-Way Ball Valve and Product
■ Measure the distance from the PE pipe connection port of the three-way ball valve to the product inlet, and then cut the PE
pipe with the measured length. The length of PE pipe should ensure that there is enough moving length to ensure the
maintenance of water purifier in the future.
■ Insert one end of the PE pipe into the PE pipe connection port of the three-way ball valve.
■ Insert the other end of the PE pipe into the water inlet on the product.
5. Connection Between Product And Faucet
■ Measure the distance from the product outlet to the water inlet of the water purification faucet, and then cut the PE pipe with
the measured length. The length of PE pipe should ensure that there is enough moving length to ensure the maintenance of
water purifier in the future.
■ Insert one end of the PE pipe into the water outlet of the water purifier.
■ Insert the other end of the PE pipe into the quick connector on the screw of the water purification faucet.
6. Placement of Products
The product is installed in the cabinet, or it can be installed in the designated position.
EN
9