Product Installation; Outer Packing And Appearance Inspection; Inspection Of Equipment With Box Items; Precautions For Installation - Viessmann Vitopure S4-RO-400G Pro Installation And Service Manual

Product Installation

Note
Outer Packing and Appearance
Inspection
Check whether the outer packing box is damaged, fallen off or loose
during transportation or loading and unloading.
Inspection of Equipment with Box
Items
Check whether the product is damaged in the packing box. Check
whether there are any missing items in the box of the product.
S4-RO-400G Pro
■ 1 set of household RO direct drinking water purifier
■ 1 double outlet faucet
■ 2 faucet quick plugs
■ 1 inlet three-way ball valve
■ Water inlet 2 m White DN10
■ Purified water outlet pipe 2m White DN8
■ Pure water outlet pipe 2m Blue DN8
■ Waste pipe 2m Orange DN8
■ 1 installation and service guide
■ 1 quality certificate
■ 1 warranty card
■ 1 packing list
Note
■ Please prepare all necessary installation materials and tools
and install them correctly according to the steps required in
the installation and service guide.
■ Please consciously abide by the national and local
regulations on pipelines, electrical appliances and health and
environmental protection during installation.
■ It is suggested to use pipe fittings that meet the national
standard of Hygienic and Safety Evaluation Standard for
Drinking Water Distribution Equipment and Protective
Materials.
8
Note

Precautions for Installation

■ The product is suitable for municipal tap water.
■ Please do not connect the unsafe or unknown water
source with the product for filtering.
■ The product is a deep filtration treatment of tap water.
■ The working water temperature of the product is
1 C~39 C, and it is not allowed to be installed on the hot
o o
water pipeline.
■ The product can be installed anywhere on the domestic
tap water pipe. But it is best to be close to the kitchen sink
for installation and maintenance.
■ Products can be installed in the kitchen cabinets or
outside the cabinets. If you need to choose another
special installation location, please contact your local
authorized service organization.
■ Use and maintenance space should be reserved during
installation.
■ The inlet and outlet PE pipes should not be bent to avoid
affecting the water flow.
■ The convenience of use and the length of PE water pipe
during cleaning and maintenance should be considered
during installation. Make sure there is enough room to
move.
■ Around the installation location, water inlet and outlet
interfaces, drainage channels and AC100~240V are
■ required. The installation position of power supply
should be far away from acid-base substances or
gases to avoid corrosion.
■ In cold areas, the equipment and connecting pipe fittings
should be insulated to prevent the products and
connecting pipe fittings from cracking.
■ The product can be restored to power supply after power
failure, and can be used normally after 30 seconds of
discharge.
EN