Replacement Of Filter - Viessmann Vitopure S4-RO-400G Pro Installation And Service Manual

Replacement of Filter

Note
This product is used to remove sediment, rust, suspended solids,
microorganisms, residual chlorine, abnormal odor and other
precipitation problems in water. If the water source itself contains
sticky sediments, such as silt and clay, it is necessary to replace the
filter regularly.
Replace No.1 Filter:
Hot-pressed polypropylene activated
carbon fiber composite filter
When the water consumption of No.1 polypropylene activated carbon
fiber composite filter reaches 5950L, the display number changes
from white to red to remind you to replace the filter.
Press the reset button for 5 seconds after replacement, and the water
consumption will be cleared, and the displayed number will change
from red to white.
When using the 400G Pro faucet, the color of the luminous seat
of the faucet changes, which is consistent with the number of the
control panel. When the water consumption reaches 6000L, the
display halo changes from white to red. After replacing the filter and
resetting, the display halo changes from red to white.
Replace the No.2 Filter:
RO Filter
When the water consumption of the No.2 RO filter reaches 3950L,
the display number changes from white to red to remind you to
replace the filter.
Press the reset button for 5 seconds after replacement, and the
water consumption will be cleared, and the displayed number will
change from red to white.
When using the 400G Pro faucet, the color of the luminous seat
of the faucet changes, which is consistent with the number of
the control panel. When the water consumption reaches
3950L, the display halo changes from white to red. After replacing
the filter and resetting, the display halo changes from red to white.
13
2
1
Note
Please install the filter according to the position shown in the figure.
The number of the filter is 2 and 1 from top to bottom. Do not install
the No.1 filter at the top.
2. RO filter
1. Hot-pressed polypropylene activated carbon fiber composite filter
Replacement of Filter
Please replace the corresponding filter in time according to the
display prompt or filter life information to avoid affecting the effluent
quality. Pay attention to the difference of inlet water quality, and the
service life of filter will be different.
Close the three-way ball valve of the water purifier, open the faucet,
relieve the pressure of the water purifier and then close the water
purifier faucet.
Turn off the power of the water purifier and unplug the power adapter
from the power socket.
Take Out the Filter
Open the front cover of the water purifier. Hold the upper end of
the filter housing and rotate it counterclockwise, then pull it out.
Replace the Filter
■ After the maintenance and replacement of the filter, rotate the
filter back and rotate the upper end of the filter shell clockwise
until it is tightened.
■ Turn on the water outlet switch after cleaning or replacement, and
check whether there is water leakage in each connecting part.
■ After installation, connect the power supply, touch the touch
switch on the machine panel, the filter operation indicator light will
light up, and slowly turn on the faucet water outlet switch.
■ It can be used normally after 30 minutes of discharge.
■ Please turn on the tap and drain the water for 30 minutes before
using the new filter for the first time. When the filter needs to be
replaced, please buy the original filter.
■ Please replace the corresponding filter in time according to the
display prompt or filter life information to avoid affecting the
effluent quality. Pay attention to the difference of inlet water
quality, and the service life of filter will be different.
EN