Solid-State Drive; Removing The Solid-State Drive - Dell NOT21996 Owner's Manual

Steps
1. Connect the battery cable to the system board, if the battery cable had been previously disconnected.
2. Align the screw holes on the base cover with the screw holes on the palm-rest and keyboard assembly, and then snap the
base cover into place.
3. Replace the six screws (M2x5) that secure the base cover to the palm-rest and keyboard assembly.
4. Tighten the four captive screws (M2x5) that secure the base cover to the palm-rest and keyboard assembly.
Next steps
1. Follow the procedure in

Solid-state drive

Removing the solid-state drive

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
38 Removing and installing Customer Replaceable Units (CRUs)
After working inside your
Before working inside your
computer.
computer.