1. How to Install 1. Rotate the EL-HS800's cover counter-clockwise to begin cable installation. 2. Remove the thumbscrew and protective plating from the goose neck wall mount. 3. Run all necessary cables (CAT 5 cable, Power Adapter cable, and the EL-HS800's power terminals) through the goose neck wall mount.
Page 3
4. Run each cable through the opening located at the top of the EL-HS800. DO NOT run all cables through the opening simultaneously. Serious blockage can occur. 5. After inserting the appropriate cables, extend each cable to 6 inches for camera installation.
Page 4
7. Use a precision knife or a sharp object to split the wire in two halves. 8. Peel the plastic sheath to expose the copper wiring. It is recommended that you use a wire stripper to remove the plastic sheath effectively. 9.
Page 5
10. Pair one half of the power cable with the red terminal of the enclosure's power supply. 11. Place the yellow wire connector over the assembly in step 10, and twist the wire connector clockwise to secure the contact between the wired pair.
Page 6
14. Slide the protective plating into the goose neck wall mount and tighten the thumb screw. 15. Screw the goose neck wall mount on top of the EL-HS800 with an Alan wrench and three hexagon socket screws. 16. Take the circular base and...
Page 7
17. Mount the assembly in step 16 using three screws. 18. Take the assembly in step 18, and use three countersunk head screws to mount the assembly on top of the 2-inch mounting screws. 19. Take the TV-IP400/TV-IP400W and turn to the bottom of the camera.
Page 8
21. Take the assembly in step 21 and mount the assembly on top of the mounting screws with regular screws. 22. Place the EL-HS800's cover over the camera and rotate the cover clock-wise. English...
Page 9
EL-HS800 - 1 Years Warranty If a product does not operate as warranted above during the applicable warranty period, TRENDnet shall, at its option and expense, repair the defective product or part, deliver to customer an equivalent product or part to replace the defective item, or refund to customer the purchase price paid for the defective product.
Page 10
PERSON TO ASSUME FOR IT ANY OTHER LIABILITY IN CONNECTION WITH THE SALE, INSTALLATION MAINTENANCE OR USE OF TRENDnet'S PRODUCTS. TRENDnet SHALL NOT BE LIABLE UNDER THIS WARRANTY IF ITS TESTING AND EXAMINATION DISCLOSE THAT THE ALLEGED DEFECT IN THE PRODUCT DOES NOT EXIST OR WAS CAUSED BY...
Page 11
Certifications This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation.
Need help?
Do you have a question about the EL-HS800 and is the answer not in the manual?
Questions and answers