Table of Contents
Advertisement
Functions/features explanation
Test procedure
The test procedure allows you to check the basic functions of the appliance.
1. Test step 1: Enter the test procedure:
a. Keep the 2-cup button and jug pressed while connecting the appliance to the mains.
b. First release the jug button and afterwards the 2-cup button, the descale (CALC) LED is switched on.
Heater and pump should be off.
2. Test step 2: 1-cup button, 1-cup LED and heater
a. Press the 1-cup button and hold it.
b. 1-cup LED and heater turn on. Other LEDs and the pump are off. Heater is on for a maximum of
3 seconds or if 1-cup button is released.
c. Release the 1-cup button.
d. Heater turns off, 1-cup LED remain on.
3. Test step 3: 2-cup button, 2-cup LED and pump
a. Press the 2-cup button and hold it.
b. 2-cup LED and pump turn on. Other LEDs and the heater are off.
c. Release the 2-cup button.
d. Pump turns off, 2-cup LED remain on.
4. Test-step 4: Test temperature sensor and descale LED
a. Press the jug button and hold it.
b. The descale LED turns on. Other LEDs and the heater are off.
c. If the temperature sensor is connected and has the right value (approx. 1.5 kOhm) the pump turns on.
d. Disconnect the temperature sensor and the pump turns off.
e. Release the jug button.
5. Test-step 5: Test water level sensor
a. Press the 1-cup button and hold it.
b. The 1-cup LED turns on. Other LEDs and the heater are off.
c. Hold a magnet for the water level sensor and the pump turns on.
d. Remove the magnet and the pump turns off.
e. Release the 2-cup button.
6. To proceed to the final test step shortly push the 1-cup button.
(Pump starts shortly, 1-cup and CALC LED remain on)
7. Test-step 7: Test Jug button
a. Press the jug button and hold it.
b. All LEDs and the heater are off.
c. The pump turns on after ± 300 ms.
d. Release the jug cup button.
e. The jug LED turns on and the pump turns off.
8. End of test procedure.
Unplug appliance from the mains to exit test procedure.
13
Advertisement
Table of Contents
