Advertisement
FINE TUNING THE POLARIS CLEANER
When operating correctly, the Polaris 280 vacuums, sweeps and scrubs all surfaces randomly
throughout the pool. The climbing ability of the Polaris depends on the pool's shape and
water pressure or flow. The Polaris climbs best in pools without sharp angles or curves in the
transition from the pool floor to the pool wall.
Approximately every 3 minutes the Polaris 280 goes into back-up mode. This action pulls the
Polaris away from pool obstacles and increases its random pattern.
Thrust Jet Adjustment
The thrust jet powers the direction of the Polaris.
Factory position is straight back, but depending on the
pool, other settings are helpful.
Sweep Hose Adjustment
The sweep hose should move in a gentle sweeping
motion. To increase or decrease its motion, turn off the
booster pump and turn the sweep hose adjustment screw.
See Troubleshooting for other action adjustments.
ROUTINE MAINTENANCE
Clean The Filter Bag
Remove the bag collar from the feed hose and depress the prongs to release the bag from
the cleaner. Open the bag closure and dump out the debris.
Zipper
Closure
In-Line Filter
To clean this screen, pull it out of the in-line
filter, rinse it and press it firmly back into place.
Storage and Winterizing
Never store the Polaris in direct sunlight. When storing for the winter, drain out all the water
(freeze damage is not covered under the warranty). Remove the UWF from the pool wall by
attaching the Quick Disconnect and using pulling pressure to unscrew. In some cases, it may
be necessary to use the UWF Removal Tool (part #10-102-00) available from an authorized
Polaris dealer.
Bag Collar
Whenever possible, empty the filter
bag when it is half full, especially if the
dirt load is sand.
It is easier to empty the filter bag when
it is dry. Alternate between two filter
bags. When one becomes full, remove
it and put on the clean bag.
12
9
3
6
Advertisement
