Seecode 236289 Manual page 12

Attachment and replacement of brush heads
• When replacing the brush head, the appliance must be switched off.
• Hold the brush head and pull it out. When pulling it out, you can
easily move the brush head back and forth.
• When attaching the brush heads and the brush disc adapter, make
sure that the semicircular groove of the brush head matches the
groove of the brush head connector.
• If you want to use the brush discs, attach them to the adapter with
the Velcro side.
Charging the battery
The Electric Cleaning Brush has a built-in rechargeable battery. Please do not expose it to heat
sources and do not place it on a heater. Recharge it regularly if you do not use it for a longer
period of time (weeks/months).
Use the enclosed charging cable and a suitable USB power adapter (not included).
When the battery charge level of the device is low, the lower light on the control panel flashes.
Open the charging port plug under the LED lights, insert the charging plug on the charging
cable into the charging port, the indicator light on the control panel starts flashing alternately.
The charging time of the unit is approx. 2-3 hours.
When all indicator lights are on, it means that the battery is charged. Remove the charging
cable and insert the sealing plug firmly.
Care and maintenance
Make sure the charging port is closed before cleaning the brush unit.
Remove the attachments from the brush unit before cleaning. Clean them thoroughly under
12