Seecode 236289 Manual page 10

Telescopic pole
The SEECODE Electric Cleaning Brush can be used with or without the telescopic pole.
Screw the 2 sections of the telescopic pole together. For an extension, open the lock at the end,
pull out the tube inside and lock the lock again. To use the telescopic rod, screw the thread of
the rod into the housing of the electric cleaning brush.
On/Off buttons Function
• Press this on/off button a little longer to switch on the cleaning brush, it then starts the fast
rotating working mode. The operating indicator (upper LED light) is constantly lit and the
current remaining power of the battery is indicated below it by the green bars.
When the appliance is in use, press the on/off button again to switch the cleaning brush to
the lower rotation mode. To stop, press the on/off button again.
• When the power is very low, the lower LED light flashes, indicating that the unit will soon
switch off. Please recharge it in time before using it again.
• In case of improper operation, e.g. too much load or blockage, 5 LED lights flash simulta-
neously. Please correct the operation in time, otherwise the unit will automatically switch
off after 5 seconds.
• During charging, the 5 indicator lights on the control panel flash to show the current battery
level.
Operating the brush attachments
To use the brush discs in fig. 1, 2, 3 and 6, you must first attach the brush adapter 5 and then
the brush discs.
The brush heads in fig. 4,7 and 8 can be attached directly to the appliance.
Before use, make sure that the battery power is sufficient.
Attach the brush head suitable for your requirements to the Electric Cleaning Brush.
Press the on/off button once a little longer for high rotation speed and again briefly for low
speed.
10