Related Manuals for ASCHER RACING B24-SC
Summary of Contents for ASCHER RACING B24-SC
- Page 1 B24-SC product manual V1.0 button plate for racing simulators Ascher Racing GmbH...
-
Page 2: Table Of Contents
table of contents 1. general information 2. Quick Release mounting 3. adjust shifter position 4. initial operation 5. general operation 6. label application 7. paddle shifter force setting 8. B24M dimensions 9. B24L dimensions 10. wiring schematic... -
Page 3: General Information
• for compatible steering wheel rims refer to the list on the product page • package contents: • B24-SC button plate – alternative magnets to adjust paddle shifter force (see foam insert) – – bolts and washers to mount wheel rim & Quick Release (such as SQR, Q1R) button &... -
Page 4: Quick Release Mounting
2. Quick Release mounting assemble steering wheel rim, button plate, QR with supplied bolts • compatible with standard 70mm QRs (maximum outer diameter of 88mm) such as: • – – –... -
Page 5: Adjust Shifter Position
3. adjust shifter position to achieve the most comfortable ergonomics, paddle location is adjustable • paddle shifters can be moved inwards by 9.5 mm each: • open button plate by removing 4 x screws (hex wrench) on the frontplate unmount paddle shifters (hex wrench) mount shifters to alternative mounting position inward screws (now located inside the casing) must be replaced with supplied shorter ones paddle can be moved closer to the wheel rim:... -
Page 6: Initial Operation
Connect automatically to paired devices • switch on steering wheel (ON-OFF switch on the rear side) • double click Ascher Racing B24 • wheel is now paired, connected and shows up in the Overview tab • check connection signal quality (Overview tab) for a full rotation of the steering wheel •... -
Page 7: General Operation
5. general operation when switched ON, the wheel will go into discovery mode for 30s (blinking LED) • if Simucube is switched on, it connects automatically and shows up in the Overview tab • LED will indicate successful connection by blinking three times •... -
Page 8: Label Application
6. label application encoder knobs must be removed to apply label (hex wrench) • to apply button labels the easiest way use a tool such as a knife • put the label on the very tip of the knife • position label centered and horizontal •... -
Page 9: Paddle Shifter Force Setting
7. paddle shifter force setting paddle shifter snap action force is set by the combination of magnets and spacers • do not let magnets smash into each other – magnets are very brittle and can break • to pull out installed magnets, put additional magnets carefully on top •... -
Page 10: B24M Dimensions
8. B24M dimensions... -
Page 11: B24L Dimensions
9. B24L dimensions... -
Page 12: Wiring Schematic
10. wiring schematic push buttons joysticks paddle shifters SC2BTEA wireless bluetooth connection Simucube antenna wireless module wheel base ON-OFF switch ER 14250 3,7 V lithium battery...
Need help?
Do you have a question about the B24-SC and is the answer not in the manual?
Questions and answers