Samsung VS15A6032R5 User Manual page 10

Operation and maintenance
B-5 Disassembling the accessories
• Disassembling the accessories
- When disassembling the pipe, press the
release button at the rear of the pipe.
- Before disassembling the accessories,
operate in MAX mode for more than 10
seconds to remove foreign matter remained
in the accessories.
- When disassembling the brush, press the
release button at the rear of the brush.
• Jet Fit Brush
- Use to clean various floor conditions at
home, it is also suitable to clean carpet.
• Mini Motorized Tool
- Use to clean bedding.
• Combination Tool
- Use to remove dust from curtains, furniture,
sofas, etc.
• Extension Crevice Tool
- Use to remove dust in grooves of window
frames, chinks, corners, etc.
C. Maintaining the vacuum cleaner
CAUTION
• Before cleaning the vacuum cleaner, turn it off.
• When the dustbin or filter is filled with
dust, the vacuum cleaner may stop due to
the overheating prevention device of the
motor.
• You should clean the dustbin or filter before
it becomes completely full (Max sign).
NOTE
• For detailed information, please
refer to the QR code.
C-1 Emptying and cleaning the dustbin
• Remove the dust on the metal mesh grille
filter with the combination tool.
- Do not pull the rubber attached to the metal
mesh grille filter.
10 English
• After emptying the dustbin, clean it and dry
in the shade.
- When heat is applied, product malformation
may occur.
C-2 Washable micro filter
• To maintain the best performance of
the filter, remove the dust on the filter
frequently and clean the filter with water
once a month.
- After cleaning, dry completely for more
than 24 hours in the shade before use.
- When heat is applied, product malformation
may occur.
C-3 Fine dust filter
• To maintain the best performance of
the filter, remove the dust on the filter
frequently and clean the filter with water
once a month.
- After cleaning, dry completely for more
than 24 hours in the shade before use.
- When heat is applied, product malformation
may occur.
NOTE
When assembling, turn the filter until the line
below the lock image is not visible.
C-4 Mini Motorized Tool
C-5 Extension Crevice Tool / Pipe
C-6 Jet Fit Brush
If the foreign matter is not removed, use
scissors to remove it.
NOTE
• If a cloth or other foreign matter is vacuumed
up and tangled with the spinning brush
(drum), the spinning brush will stop working
to protect the brush motor. After cleaning the
brush, turn the power off and then on again.
• If a brush does not work after cleaning, turn
the power off and then on again.
• When cleaning the brush, be careful not to
catch your fingers in the fold of the brush.