FOR YOUR SAFETY – This product must be installed and serviced by a contractor who is licensed and qualified in pool equipment in accordance with the latest applicable version
of AS3633, along with any other applicable local or council codes/standards. Before installing this product, read and follow all warning notices and instructions that accompany this
product. Failure to follow warning notices and instructions may result in property damage, personal injury, or death. Improper installation and/or operation may void the warranty.
Improper installation and/or operation can create unwanted hazards which may cause serious injury, property damage, or death.
ATTENTION INSTALLER – This manual contains important information about the installation, operation and safe use of this product. This information should be
Page 1
Installation Manual LumiPower Pool and Spa LED Lights Light Engine WARNING FOR YOUR SAFETY – This product must be installed and serviced by a contractor who is licensed and qualified in pool equipment in accordance with the latest applicable version of AS3633, along with any other applicable local or council codes/standards.
Page 2
Serial No. : AUSTRALIA WARRANTY: For full warranty terms and conditions and to register your warranty, visit www. zodiac.com.au/warranty and complete your details. Or scan the QR code to go directly to the registration page. NEW ZEALAND WARRANTY: For full warranty terms and conditions and to register your warranty, visit www.
NOTICE The Zodiac Pool and Spa niches are intended for installation in fresh water and salt water swimming pools and spas. It is important to ensure that the lights in which the niches are installed are intended for their appropriate application, either fresh water or salt water.
LumiPower Pool and Spa LED Lights Light Engine | Installation Manual ® Section 2. Package Contents Turn the LumiPower light onto its cover to view the underside and connection port. Remove the red protective cap from the cable plug. Discard the three screws and the O-Rings.
12. Before filling the pool, check the light is functioning by switching it on for a few seconds. Pool Surface Cutout Figure 4. Lumipower Light Engine Concrete Note: Installed Installation in pool wall. NOTE: Do not look directly at the light whilst it is operating. Figure 6.
Section 5. Existing Pool Retrofit Lumipower 2.5m Cable Connection If necessary, cut off the old connector from The LumiPower Light has been designed to be the existing power cable. Trim the supplied compatible with other light vendors’ mounting Lumipower power cable so that, once joined, methods.
Page 8
Zodiac LumiPower Pool and Spa LED Lights Light Engine | Installation Manual ® Glue Glue Figure 9. Proper and Improper Solder Ball Positions Figure 12. Completed Heat-shrink Tube Application Using a heat gun on Medium to High heat, 11. Leave the completed joint to COOL for five gently heat the centre of the solder splices (5) minutes to ensure that the glue seal isn’t...
Page 9
Zodiac LumiPower Pool and Spa LED Lights Light Engine | Installation Manual ® Page 9...