FOR YOUR SAFETY – This product must be installed and serviced by a contractor who is licensed and qualified in pool equipment in accordance with the latest applicable version
of AS3633, along with any other applicable local or council codes/standards. Before installing this product, read and follow all warning notices and instructions that accompany this
product. Failure to follow warning notices and instructions may result in property damage, personal injury, or death. Improper installation and/or operation may void the warranty.
Improper installation and/or operation can create unwanted hazards which may cause serious injury, property damage, or death.
ATTENTION INSTALLER – This manual contains important information about the installation, operation and safe use of this product. This information should be
Page 1
Installation Manual LumiPower Light for Fiberglass Pools WARNING FOR YOUR SAFETY – This product must be installed and serviced by a contractor who is licensed and qualified in pool equipment in accordance with the latest applicable version of AS3633, along with any other applicable local or council codes/standards. Before installing this product, read and follow all warning notices and instructions that accompany this product.
Page 2
Serial No. : AUSTRALIA WARRANTY: For full warranty terms and conditions and to register your warranty, visit www. zodiac.com.au/warranty and complete your details. Or scan the QR code to go directly to the registration page. NEW ZEALAND WARRANTY: For full warranty terms and conditions and to register your warranty, visit www.
NOTICE The Zodiac Pool and Spa niches are intended for installation in fresh water and salt water swimming pools and spas. It is important to ensure that the lights in which the niches are installed are intended for their appropriate application, either fresh water or salt water.
Run a bead of silicone around the back face Lumipower Light Engine - Concrete of the niche. Ensure the silicone runs as one 1. Fiberglass Niche Assembly continuous line approximately 10mm to 15mm 2.
Page 6
LumiPower Lights for Fiberglass Pools | Installation Manual ® From outside of the pool, feed the Washer and 10. Zodiac recommends that a vertical length of then the Nut (large face first) onto the cable. conduit, finishing above the waterline, is glued Again, there is no need to uncoil the cable, into the conduit connection point.