Installation - Zanussi ZQA14032DA User Manual

Problem
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.
Replacing the lamp
Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.
2. Remove the lamp cover (refer to the
illustration).

Installation

WARNING!
Refer to Safety chapters.
Location
Refer to the assembly instructions
for the installation.
To ensure best performance, install the
appliance well away from sources of heat such
as radiators, boilers, direct sunlight etc. Make
sure that air can circulate freely around the back
of the cabinet.
Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate class
indicated on the rating plate of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
www.zanussi.com
Possible cause
There is no cold air circulation in
the appliance.
3. Replace the used lamp with a new lamp of
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door.
Make sure that the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective door
Climate
N
ST
T
Make sure that there is cold air
circulation in the appliance.
the same power and specifically designed
for household appliances (the maximum
power is shown on the lamp cover).
"Installation".
gaskets. Contact the Authorised Service
Centre.
Ambient temperature
class
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation can
only be guaranteed within the
specified temperature range. If you
have any doubts regarding where to
install the appliance, please turn to
the vendor, to our customer service
or to the nearest Authorised Service
Centre.
Solution
9