Advertisement
EQUIPMENT SET UP & OPERATION :
- Once the unit has been taken out of the shipping carton and has been unpackaged, check to
make sure that the lightbulb is securely in its socket.
- Before loading prepared food product into the warmer, you must preheat the unit for 30 minutes
at a setting of 4 or 5 on the thermostat dial. After the preheat time has elapsed you can then go
ahead and place the previously prepared food product inside and adjust the thermostat
accordingly.
- The amount of product placed in the warmer will affect the performance of the warmer.
We suggest periodically checking the internal temperature of product and adjusting the
temperature settings if necessary. Keep door(s) closed when not serving.
- If your unit comes with the humidity option please be sure to fill pan with appropriate amount
of water.
TO REPLACE DISPLAY LIGHT/BULB:
Only shatter resistant light bulbs which meet or exceed NSF Standards specifically designed for food holding units must be used.
!
Breakage of bulbs not specially coated could result in personal injury and/or food contamination.
- Disconnect the power supply cord and wait until unit has completely cooled. Remove bulb guard and
light bulb and replace with a new bulb. Same style and wattage.
TROUBLESHOOTING:
!
Unplug unit from power source and allow to cool completely before performing any maintenance or cleaning.
Unit not working:
- Check power switch position, power cord and/or electrical circuit.
Display Light not working:
- Tighten or replace bulb
Loud noise coming from the unit:
- Check to see that blower motor is functioning properly
Unit not heating properly:
- Has food been prepared in advance and placed in warmer at proper serving temperature?
- Check heat settings. Is it at the correct setting for your food product?
- Turn unit on, open the door and verify that hot is air is being blown into unit.
If not, your blower motor is not functioning properly.
- If the air being blown in is not hot then the thermostat is not functioning properly.
If you have further questions in regards to this piece of equipment - please contact Wisco Industries, Inc.
directly at: (608)835-3106 or (800)999-4726; fax (608)835-8273 for further information.
*Please be sure to have the complete model # and serial # available.
Advertisement
