JET sells through distributors only. The specifications listed in JET printed materials and on official JET website are given as general information and are not binding. JET reserves the right to effect at any time, without prior notice, those alterations to parts, fittings, and accessory equipment which they may deem necessary for any reason whatsoever.
11-9/32 x 9-7/16 The above specifications were current at the time this manual was published, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations.
Turning the release valve too Unpacking quickly will make the load fall rapidly, and may lead to loss of load or damage to the jack. Open shipping carton, which should contain one Failure to heed may cause serious injury and/or toe jack and one 2-piece handle.
Troubleshooting JTJ-ST Toe Jacks Trouble Probable Cause Remedy Release stem is open. Close release stem completely. Toe will not extend. Dirt or crack in valve sealing section. Clean and repair or replace. Jack will not lift to full Not enough or too much hydraulic jack Fill reservoir with correct amount of height.
Page 7
Parts List for JTJ-2ST 2-Ton Toe Jack Index No. Part No. Description Size 1 ....JTJ2ST-01 ....Rear Handle ....................1 2 ....JTJ2ST-02 ....Front Handle ....................1 3 ....JTJ2ST-03 ....Sealing Bolt ....................1 4 ....
Page 9
Parts List for JTJ-5ST 5-Ton Toe Jack Index No. Part No. Description Size 1 ....JTJ5ST-01G ....Body ......................1 2 ....JTJ5ST-02 ....Safety Valve Screw ..................1 3 ....JTJ10ST-03 ....O-Ring ..............7.1x2.65mm ....2 4 ....
Page 10
Parts List for JTJ-10ST 10-Ton Toe Jack Index No. Part No. Description Size 1 ....JTJ10ST-01G .... Body ......................1 2 ....JTJ10ST-02 ....Safety Valve Screw ..................1 3 ....JTJ10ST-03 ....O-Ring ..............7.1x2.65mm ....2 4 ....