Download Print this page

Specifications - Jet JTJ-2ST Operating Instructions And Parts Manual

Toe jack

Advertisement

Warning
1.
Read and understand the entire owner's manual before attempting to operate the toe jack.
2.
This toe jack was designed and intended for use by properly trained personnel only. If you are not familiar
with the proper and safe use of a toe jack, do not use this jack until proper training and knowledge have
been obtained.
3.
Use the jack on hard, level surfaces only. Never use the jack on a slope or soft surfaces.
4.
Never load the toe jack beyond its rated capacity.
5.
Support raised loads with appropriate supports. Never use the toe jack as a sole means of support.
6.
Keep arms, legs, fingers and toes clear of a lifted load at all times.
7.
Do not add weight to a supported load.
8.
Keep lifted loads as low as possible.
9.
Remove the handle from the toe jack body when not in use. Never use any handle other than the one
designed for the toe jack.
10. Retract the ram completely when you are finished using the jack. An extended ram might get damaged.
11. Do not lower a load suddenly and stop in the middle of a lift. Damage to the jack may occur.
12. Replace the warning label on the jack if it is damaged or unreadable.
13. Failure to comply with all these warnings may cause serious injury and/or damage to property.
WARNING: This product can expose you to chemicals including lead and cadmium which are known to
the State of California to cause cancer and birth defects or other reproductive harm, and phthalates which
are known to the State of California to cause birth defects or other reproductive harm. For more information
go to http://www.p65warnings.ca.gov.

Specifications

Toe
Stock
Capcty
Model
No.
(tons)
JTJ-2ST
454502
2
JTJ-5ST
454505
5
JTJ-10ST
454510
10
The above specifications were current at the time this manual was published, but because of our policy of
continuous improvement, JET reserves the right to change specifications at any time and without prior notice,
without incurring obligations.
Toe
Toe
Head
Height
Height
Capcty
min.
max.
(tons)
(in.)
(in.)
3
5/8
5-1/16
6
1-1/16
5-3/4
14
1-7/32
6-15/16
Head
Head
Height
Height
Toe Lift
min.
max.
(in.)
(in.)
(in.)
4-7/16
9-1/4
13-3/4
4-11/16
11-1/2
16-1/4
5-23/32
12-7/8
18-9/16
3
Toe Size
Base Size
(L x W)
(L x W)
(in.)
(in.)
2 x 2
4-15/16 x7
2.5 x 3
10-5/8 x 7-3/16
2.72 x 3.3
11-9/32 x 9-7/16
Net
Weight
(lbs.)
20
48
81

Advertisement

loading

This manual is also suitable for:

Jtj-5stJtj-10st