Advertisement
WCP-EX-0006 - Application Guide
(Rev 1)
Flipped Hooks
The image below shows example hooks that could be used for either of the Flipped
configurations. The hooks are made from 1/8" thick aluminum and are bolted together
using 1"L spacers. These will help keep the hooks from bending.
A 3/8" OD Shaft is used as the anchor point for the string. Unlike the Non-Flipped Hooks,
the shaft is installed outside the tube for the Flipped configurations. The position for the
shaft is indicated in the image below.
Note: When designing your hook, make sure that the anchor point does not cause the
string to collide with any of the CF Springs�
Table of Contents
Page 5
wcproducts.com
Advertisement
