Table of Contents
Advertisement
6.4 GENERAL PERFORMANCE
Power requirement
Dimensions (W x H x D)
Weight
6.5 ENVIRONMENTAL CONDITIONS
• Temperature
• Humidity
6.6 PICK UP LASER
• Type
• Wave Length
• Divergence
• Output power
CHAPTER 7 BEFORE REQUESTING SERVICE
7.1 TROUBLESHOOTING
(1) There are many kinds of problems caused by misuse. When a problem occurs,
check the table below which describes possible problems occurring with your
CD-ROM drive.
(2) If the CD-ROM drive is not operating correctly and you cannot restore operation by
following the detailed procedures in the table below, do not remove the cover of
the units or adjust further.
(3) In the case of (2) above, unplug the unit and consult with your dealer or the nearest
service station.
TROUBLE
• CD-ROM drive does not op-
erate and Busy Indicator
does not light.
+5 V
+12 V
146 x 41.3 x 190 mm (exclude Front Bezel)
865 g typical
Operating
5 ~ 50 °C
5 ~ 90 %Rh
(Non-condensation)
Semiconductor laser AlGaAs
760 ~ 815 nm (Typical 785 nm)
θ = 53.5 °
0.15 mW
Confirm that the connection between the CD-ROM drive
and the host computer is correct.
Confirm that the program is correct.
Confirm that the setting drive select switch is correct.
Confirm that the disc has been inserted label side up.
Confirm that foreign objects have not been inserted.
1.5 A
1.8 A
Non-operating
– 30 ~ 65 °C
5 ~ 95 %Rh
(Non-condensation)
CORRECTION
A-9
Advertisement
Table of Contents
