Preparation - Fujitsu AUY7UI-MI Operating Manual

PREPARATION

Load Batteries (R03/LR03 × 2)
1
Press and slide the battery compartment lid on the
reverse side to open it.
Slide in the direction of the arrow while pressing the
2
Insert batteries.
Be sure to align the battery polarities (
3
Close the battery compartment lid.
Set the Current Time
1
Press the CLOCK ADJUST button.
Use the tip of a ball-point pen or other small object to press the button.
2
Use the TIMER SET (
clock to the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in
1 minute increments; hold the buttons depressed to change the time quickly
in 10 minute increments.)
3
Press the CLOCK ADJUST button again.
This completes the time setting and starts the clock.
To Use the Remote controller
The Remote controller must be pointed at signal receiver to operate correctly.
●
Operating range: About 7 meters.
●
When a signal is properly received by the air conditioner, a beeping sound will be
●
heard.
If no beep is heard, press the Remote controller button again.
●
Remote controller Holder
Insert
Press in
Screws
1 Mount the 2 Set the Remote con-
Holder. troller
En-6
mark.
) correctly.
/ ) buttons to adjust the
Slide up
Pull out
3 To remove the Remote con-
troller (when use at hand).
CAUTION
Take care to prevent infants from acciden-
●
tally swallowing batteries.
● When not using the remote controller for an
extended period, remove the batteries to
avoid possible leakage and damage to the
unit.
● If leaking battery fl uid comes in contact
with your skin, eyes, or mouth, immediately
wash with copious amounts of water, and
consult your physician.
Dead batteries should be removed imme-
●
diately and disposed of properly, either in a
battery collection receptacle or to the appro-
priate authority.
● Do not attem pt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about 1 year under
normal use. If the remote controller's oper-
ating range becomes appreciably reduced,
replace the batteries and press the RESET
button with the tip of a ballpoint pen or
other small object.