Sauder OFFICE WORKS AFFIRM 427869 Manual page 7

Step 2
å
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten two EXTENSION RAILS (40MA) to the RIGHT END (A). Use four GOLD 5/16" FLAT HEAD SCREWS (3S) through
holes #1 and #4.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner cartridge
of the EXTENSION RAIL in to find the other hole that lines up with the hole in the END. Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
40MC
Push the black lever in and pull the SLIDE from the RAIL.
Edge with
TWIST-LOCK®
FASTENERS
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
www.sauder.com/commercial-office/service
2
3
4
A
427869
40MA
1
These holes
must be here.
2
3
4
7
Open end
1
Page 7