Advertisement
Available languages
Available languages
Step 11
1
D581
Groove
å
Insert the DRAWER SIDES (D581 and D582) at an angle
into the slot at each end of the DRAWER FRONT (G).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
å
Fasten the DRAWER BACK (D78) to the DRAWER SIDES (D581 and D582). Use four BLACK 1-9/16"
FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D707) inserts into the groove of the DRAWER BACK (D78).
å
Repeat this step for the other drawer.
Page 16
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D582
G
D78
D581
D707
2
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D707) into the grooves
in the DRAWER SIDES (D581 and D582) and
DRAWER FRONT (G).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D582
427869
With the palm of
your hand, tap
the DRAWER
U n fi
BOTTOM down
n i s h
s u r
e d
f a c
into the groove.
e
D707
D581
D582
G
30S
(8 used in this step)
www.sauder.com/commercial-office/service
9
Advertisement
