TP-Link TL-R4199G User Manual page 79

2. How do I configure the router to access Internet by Ethernet users?
Step 1: Login to the router, click the menu Network→WAN on the left of your browser, On the
WAN screen, select "Dynamic IP" for "WAN Connection Type", and finish it by clicking
Save.
Step 2: Some ISPs require that you register the MAC address of your adapter, which is
connected to your cable or DSL modem during installation. If your ISP requires MAC
register, login to the router and click the menu Network→MAC Clone. On the MAC
Clone screen, if your PC's MAC address is a proper MAC address, click the "Clone MAC
Address" button and your PC's MAC address will be filled in the "WAN MAC Address"
field; Or else, enter the specific MAC address into the "WAN MAC Address" field
manually. Then click the Save button. It will take effect after rebooting.
3. I want to use Netmeeting, what do I need to do?
1) If you start a Netmeeting as a host, no configuration is needed but entering the invitee's IP
address.
2) If you start a Netmeeting as an invitee, you need to configure Virtual Server or DMZ Host first.
Method one: Use Virtual Server
Login to the router, click the menu Forwarding→Virtual Servers. On the Virtual Server screen,
add a Virtual Server rule as shown in the next screen: configure 1720 as the "Service Port" and
enter your IP address (assuming 192.168.1.102 for an example), then click select the status
Enabled and click Save.
TL-R4199G SMB Broadband Router User Guide
Figure B-3
73