Table of Contents
Advertisement
en Troubleshooting
Fault
Remnants of food on
tableware.
Removable streaks
are present on
glasses, glassware
with a metallic appear-
ance and cutlery.
Rust spots on cutlery. Cutlery is not sufficiently rust-resistant. Knife blades
Detergent residue is
present in the deter-
gent dispenser or the
tablet collecting tray.
Special salt refill indic-
ator lights up.
46
Cause and troubleshooting
Set the upper basket on the left and right to the
▶
same height.
→ "Top basket", Page 20
Amount of rinse aid to be dispensed is set too high.
Set the rinse aid system to a lower setting.
▶
→ "Setting the amount of rinse aid", Page 26
No rinse aid has been added.
Add rinse aid.
▶
→ "Adding rinse aid", Page 26
Detergent residue is present in the final rinse. Lid of
the detergent dispenser is blocked by tableware items
and will not open fully.
Arrange tableware in the top basket tableware so
1.
the tab collecting tray is not obstructed by table-
ware.
→ "Arrange tableware", Page 30
Items of tableware are blocking the dispenser lid.
Do not place tableware or fragrance dispensers in
2.
the tablet collecting tray.
are often more severely affected.
Use rust-resistant tableware.
▶
Cutlery may also rust if washed together with rusting
items.
Do not wash rusting items.
▶
Salt content in washing water is too high.
Remove any spilled special salt from the tub.
1.
Screw the cap of the special salt dispenser on tight.
2.
Spray arms were blocked by tableware so detergent
was not rinsed out.
Check that the spray arms are not blocked and can
▶
rotate freely.
Detergent dispenser was damp when detergent was
added.
Only add detergent to a detergent dispenser when
▶
dry.
Insufficient special salt.
Add Special salt → Page 24.
▶
Sensor does not detect special salt tablets.
Do not use special salt tablets.
▶
Advertisement
Table of Contents
