Table of Contents
Advertisement
en Troubleshooting
Fault
E:61-03 will light up
alternately. Water is
not drained.
All LEDs lit up or
flashing.
44
Cause and troubleshooting
Not an appliance fault. Siphon connection is still
closed or the wastewater hose is kinked or blocked.
Check the connection to the siphon and open if ne-
1.
cessary.
Install wastewater hose without kinks.
2.
Remove residues.
3.
Not an appliance fault. Wastewater pump is blocked
or the cover of the wastewater pump is loose.
Clean the wastewater pump.
1.
→ "Clean wastewater pump", Page 47
Secure the cover of the wastewater pump so it
2.
clicks into position.
→ "Clean wastewater pump", Page 47
Electronics have detected a fault.
Press the main switch button for approx.
1.
4 seconds.
The appliance is reset and restarted.
If the problem occurs again:
2.
Switch off the appliance.
‒
Pull out the mains plug or switch off the fuse in
‒
the fuse box.
Wait at least 2 minutes.
‒
Switch on the fuse in the fuse box or insert the
‒
mains plug.
Switch the appliance on.
‒
If the problem occurs again:
3.
Contact customer service.
‒
→ "Customer Service", Page 48
Advertisement
Table of Contents
