Installing Outdoor Unit - Trane 4MXW6 Installation Manual

Hide thumbs Also See for 4MXW6:
Table of Contents

Advertisement

Installation
Connect indoor and outdoor electric wires
Hazardous Voltage!
Disconnect all electric power, including remote disconnects before servicing. Follow
proper lockout/tagout procedures to ensure the power can not be inadvertently
energized. Failure to disconnect power before servicing could result in death or serious
injury.
1.
2.
3.
4.
5.
6.
7.

Installing Outdoor Unit

Wiring
Hazardous Voltage!
Disconnect all electric power, including remote disconnects before servicing. Follow
proper lockout/tagout procedures to ensure the power can not be inadvertently
energized. Failure to disconnect power before servicing could result in death or serious
injury.
1.
2.
3.
4.
5.
Note: Wrong wiring may cause spare parts malfunction.
Note: After the cable fixed, make sure there should be a free space between the connection and
12
WARNING
Open the front panel upwardly.
Screw off the fixing screw of cover plate and screw off cover plate.
Put the power connection cable through the back of indoor unit wire hole and take it out.
All the wiring should be connected according to the circuit diagram on the unit.
Put the power connection cable the section, which with sheath into wire groove, and cover
the cover plate, screw on the fixing screw, tighten the connection wire.
Cover the front panel cover.
For the cooling and heating unit, signal control wire can be passed through the connection of
connector and indoor unit, and use the wire clip that is under the body case, tighten the
signal control wire.
WARNING
Disassemble handle of right side plate or front side plate of outdoor unit.
Take off wire clamp, connect and fix power connect cord to terminal of line bank. Wiring
should fit that of indoor unit.
Fix the power connection cable with wire clamp, for cooling and heating unit, then use the
wire clamp to fix the signal control wire, then connect the corresponding connector.
Ensure if wire has been fixed well.
Install handle or front side plate.
fixing place on the lead wire.
MXW-SVN15A-EN

Advertisement

Table of Contents
loading

This manual is also suitable for:

4txk6

Table of Contents