Getting Started - Texas Instruments TI-5045SVC Manual Book

Getting Started

Installing the Paper Roll
1. Lift the paper holder so that it extends behind the calculator.
2. Make sure the calculator is plugged into an easily accessible
electrical outlet near the calculator.
3. Move the
POWER
4. Insert the end of the paper into the paper slot on the back of the
calculator as shown. To avoid paper jams, use quality bond paper.
5. While feeding the paper into the slot, press and hold &.
6. Place the paper roll on the paper holder.
To prevent damaging the printer (which may void the warranty),
Note
move the
POWER
paper.
Replacing the Ink Roller (IR-87T)
1. Tear off the paper between the paper roll and the calculator, and
then press & to run out the remaining piece of paper.
2. Move the
POWER
3. Remove the clear plastic printer compartment cover.
4. Grasp the tab on top of the red roller and gently lift the roller out of
the compartment.
switch to
ON
switch to when operating the calculator without
ON
switch to
OFF
.
.
1