Flex FX4331 Operator's Manual page 15

LED WORK LIGHTS (FIG. 8)
The LED work lights will illuminate when the
trigger switch or the workpiece contact is
depressed. This provides additional illumination
of the surface of the workpiece for operation in
lower light areas.
The LED work lights will turn off within
approximately 10 seconds after the trigger
switch is released.
REMOVING A JAMMED BRAD NAIL
(FIG. 9A - 9B)
a. Remove the battery pack from the tool.
b. Press the magazine release button and
remove the nails from the magazine.
c. Lift the jam release latch and open the jam
release.
d. Remove the jammed nail using a flat head
screwdriver or pliers if necessary.
NOTICE: Do not mar/scratch the nail channel
or driver mechanism. The screwdriver should
always slip over the nail when prying.
e. Close the jam release and the latch.
f. Reload the nails and close the magazine.
g. Reattach the battery pack and restart the tool
by pressing the power switch.
NOTE: Driving the nails too deeply into the
material, excess debris, or jammed nails may
lead to a driver blade being stuck at its bottom
position.
The driver blade can usually be returned to
its operating position by depressing the work
contact element against a scrap piece of wood
and squeezing the trigger.
Fig. 8
Fig. 9a
Jam Release
Latch
Fig. 9b
-15-
LED Work Light
Jam Release