Flex FX4331 Operator's Manual page 12

NO-MAR PAD (FIG. 4)
WARNING
removing or replacing the no-mar pad.
Failure to do so could result in serious personal
injury.
The no-mar pad attached to the nose of the
tool helps prevent marring and denting the work
surface when working with softer woods.
The no-mar pad can be removed by pulling it
down and away from the workpiece contact. To
replace the no-mar pad, fit it into place over the
workpiece contact and push up at the back to
reseat.
On-board storage for the no-mar pad is located
on the magazine of the tool. A spare no-mar pad
is provided in the on-board storage area.
TO LOAD OR REMOVE BRAD NAILS (FIG. 5)
WARNING
loading or removing nails. Failure to do so
could result in serious personal injury.
WARNING
others when loading nails. Failure to do so
could result in possible serious personal injury.
WARNING
this tool. The use of any other nails can result
in tool malfunction, leading to serious injuries.
WARNING
activated. Doing so could result in possible
serious personal injury.
To Load Brad Nails:
a. Remove the battery pack from the tool.
b. With the nose of the tool pointed away from
you, squeeze the magazine release button
located at the rear of the magazine and slide
the magazine open.
c. Place the brad nails in the channel with the
nail tips pointing down and resting on the
bottom of the channel.
d. Push the magazine and squeeze the
magazine release button to close it until it
securely snaps into place.
e. Make sure that the magazine is securely
locked in place.
Remove the battery pack
from the tool before
Remove the battery pack
from the tool before
Keep the tool pointed
away from yourself and
Use only the nails
recommended for use with
Never load nails with the
workpiece contact or trigger
Fig. 4
On-board Storage
Fig. 5
Top
f. Reattach the battery pack, and reactivate the
nailer by pressing the power switch.
You can observe the number of remaining nails
through the nail indicator windows, and load
more nails as needed.
To Remove Brad Nails:
a. Remove the battery pack from the tool.
b. Squeeze the magazine release button located
at the rear of the magazine and slide the
magazine open.
c. Remove the nails.
d. Close the magazine and make sure that it is
securely locked in place.
-12-
No-mar Pad
Magazine
Nail
Indicator
Windows
Nail Tips
Magazine
Release
Button