Page 1
We recommend the unit be mounted at the front edge of the cabinet. Important: For secure mounting, the screws must go into the radio to a depth of at least . If the overall length from the bottom of the cabinet shelf to the bottom of the over 3/8”...
Page 2
Mounting Procedure Step 1. If your cabinet does not have a overhang : Position template in desired location on underside of cabinet, flush with front edge. Then tape template in place and go to step 2. If your cabinet has an overhang: a) Measure the thickness of the overhang.
Page 3
Step 2 Drill 3/16” inch diameter holes through the underside of the cabinet bottom shelf using the three points marked on the template. Helpful Hints: On wooden cabinets you may want to mark and start the drill holes with a nail or an awl. Be sure to hold the drill very firmly against the cabinet to reduce “walking”...
Page 4
Be sure to push up spacers until they are fully nested (if more then one is in used) Step 7 Align radio under the screws. Hold the screw holes in the top of the clock radio against the mounting screws and partially tighten the screws.