Advertisement
Step 5.
Insert screws from inside the cabinet. The washers must be used on metal cabinets, and
on wood cabinets if you did not countersink the drilled holes. Position washers, flat side
down, and place screws into the holes.
If your cabinet does not have an overhang, go to Step 7.
Step 6.
Hold screw heads down while you push the selected spacers onto the screws under the
cabinet. Be sure to push up spacers until they are fully nested (if more then one is in used)
Step 7
Align radio under the screws. Hold the screw holes in the top of the clock radio against
the mounting screws and partially tighten the screws.
Do not fully tighten until all 3 screws have been started. (The top front edge of the clock
radio should clear the overhang.)
Advertisement
