Advertisement
Step 2
Drill 3/16" inch diameter holes through the underside of the cabinet bottom shelf using
the three points marked on the template.
Helpful Hints:
On wooden cabinets you may want to mark and start the drill holes with a nail or an awl.
Be sure to hold the drill very firmly against the cabinet to reduce "walking" of the drill
bit from the markings.
Use masking tape above the hole locations on inside of wooden cabinet shelf to help
reduce splintering.
If installing the unit under a wood cabinet, you may wish to countersink the drilled holes
from the INSIDE of the cabinet. If you opt not to countersink the holes, use the supplied
washers.
Step 3
Remove template and clean drill shavings from inside and underside of cabinet.
Step 4
If your cabinet does not have an overhang. Go to Step 5.
If your cabinet has an overhang. Select the spacer or combination of spacers that is equal
to or longer than the cabinet overhang.
Installation with supplied washers (no Countersink)
Advertisement
