Tire Safety; Cylinder Stops - MASSEY FERGUSON MF2800 Series Operator's Manual

FIG. 22: Use a piece of cardboard or wood to search for
possible leaks. Do not use your bare hand. Wear leather
gloves for hand protection and safety goggles for eye
protection.
Relieve all pressure before loosening any hydraulic lines.
Relieve the pressure by lowering raised equipment,
shutting off accumulator valve, if equipped, and shutting
off the engine. Tighten all connections securely before
applying pressure.

Tire Safety

FIG. 23: Check tires for cuts, bulges, and correct
pressure. Replace worn or damaged tires. When tire
service is needed, have a qualified tire mechanic service
the tire. Tire changing can be very hazardous and must
be done by qualified tire mechanic using proper tools and
equipment. See the Specifications Section for the correct
tire size.
Tire explosion and/or serious injury can result from over
inflation. Do not exceed the tire inflation pressures. See
the Specifications Section for the correct tire pressure.
Do not inflate a tire that is seriously under inflated or has
been run flat. Have the tire checked by qualified tire
mechanic.
Do not weld on the rim when a tire is installed. Welding
will make an air/gas mixture that can cause an explosion
and burn with high temperatures. This danger applies to
all tires, inflated or deflated. Removing air or breaking the
bead is not enough. The tire must be completely removed
from the rim prior to welding.

CYLINDER STOPS

FIG. 24: When the tailgate is raised for any maintenance
or service work, put the tailgate lockout valve (1) into the
LOCKED position (pushed in).
The tailgate can only be lowered when the tailgate lockout
valve is released (pulled out).
700734980 D Rev.
FIG. 22
FIG. 23
1
FIG. 24
SAFETY
D-5842A
D-8386
NB21380
A-15