Table of Contents
Advertisement
Tire Safety
FIG. 21: Check tires for cuts, bulges, and correct
pressure. Replace worn or damaged tires. When tire
service is needed, have a qualified tire mechanic service
the tire. Tire changing can be very hazardous and must
be done by qualified tire mechanic using proper tools and
equipment. See the Specifications Section for the correct
tire size.
Tire explosion and/or serious injury can result from over
inflation. Do not exceed the tire inflation pressures. See
the Specifications Section for the correct tire pressure.
Do not inflate a tire that is seriously under inflated or has
been run flat. Have the tire checked by qualified tire
mechanic.
Do not weld on the rim when a tire is installed. Welding
will make an air/gas mixture that can cause an explosion
and burn with high temperatures. This danger applies to
all tires, inflated or deflated. Removing air or breaking the
bead is not enough. The tire must be completely removed
from the rim prior to welding.
Lower planter to the ground before attempting to remove
a wheel for tire repair.
SAFETY SIGN LOCATION
General
The following safety signs are installed to alert operators
to hazards in specific machine areas. The signs are for
personal safety. READ AND UNDERSTAND THE
SIGNS!
Keep signs clean by wiping off regularly. Use a cleaning
solution if necessary.
Replace signs if missing, damaged or painted.
If a used machine has been purchased, make sure that all
the safety signs are in the correct place and are readable.
Clean machine surface thoroughly with a cleaning
solution before replacing signs.
FIG. 22: PTO Pump
700744111 B Rev.
FIG. 21
FIG. 22
SAFETY
D-8386
1
31660c
A-15
Advertisement
Table of Contents
