Table of Contents
Advertisement
You are able to set alarms before the actual dive. The preset user programmable
alarms can be set for time, dive time and maximum depth. The alarms activate
when:
•
The preset alarm time is reached (Fig. 3.31)
- the current time is shown
- continuous beep series for 24 seconds or until any button is
pressed
- the current time blinks for one minute, if no button is pressed.
•
The preset dive time is reached (Fig. 3.32)
- continuous beep series for 24 seconds or until any button is
pressed
- the dive time blinks for one minute, if no button is pressed.
•
The preset maximum depth is reached (Fig. 3.33)
- continuous beep series for 24 seconds or until any button is
pressed
- the maximum depth blinks as long as the present depth value
exceeds the adjusted value.
OXYGEN WARNINGS IN THE NITROX MODE
Three double beeps and the backlight for 5 seconds activate when:
•
the OLF bar graph reaches 80%. The segments exceeding the 80% limit
start to blink (Fig. 3.23)
•
the OLF bar graph reaches 100%.
The blinking of the segments exceeding 80% will stop, when the OLF is not
loading anymore. At that point the PO
Continuous beeps for 3 minutes and the backlight for 5 seconds, occur when:
•
the set oxygen partial pressure and equivalent depth limit is exceeded.
The maximum depth is replaced with a current blinking PO
should immediately ascend above the PO
36
is less than 0.5 bar.
2
depth limit (Fig. 3.23).
2
value. You
2
Hide quick links:
Advertisement
Table of Contents
