Suunto Vyper User Manual page 63

9. Check that the battery compartment, battery holder and lid are clean.
Clean with soft cloth if necessary.
10. Gently insert the new battery in the battery compartment. Check the
polarity of the battery: the "-" mark should point toward the bottom of
the compartment and the "+" mark upwards.
11. Reinstall the battery retainer in its correct position.
12. Check that the new lubricated O-ring is in good condition. Put it in the
right position on the battery compartment lid. Be very careful not to get
any dirt on the o-ring or its sealing surfaces.
13. Carefully press the lid onto the battery compartment with your thumb,
while making sure that the O-ring is not at any point protruding out on
the edge.
14. Put your other thumb through the locking ring. Press this thumb fi rmly
against the lid and release the other one. Make sure that the lid is pressed
completely down!
15. Turn the locking ring counterclockwise with your free thumb and fi ngers
until it snaps into its locked position.
16. The dive computer should now active it's timekeeping mode and show
time 18:00 [6:00 PM] and date SA 01,01. Activate the instrument. Check
that:
• All display segments work.
• The low battery warning is off.
• The buzzer beeps and backlight works.
• All the settings are correct. Reset if necessary.
17. Install the dive computer back into the console or boot and reassemble
the strap. The instrument is now ready for use.
Wrist model:
• Assembling into the boot: First insert the longer strap in its hole in the
front of the boot and then the dive computer into its cavity in the boot
starting at the back end. Then snap also the long strap end of the
instrument into the boot. Stretch the boot as needed.
• Assemble the shorter part of the strap. Use the spring bar
screwdriver to compress the spring bars. Make sure that the spring bars
get fully seated so they will not come off their holes.
Console model:
• Refi t the dive computer in the console according the instructions of the
console.
tool or small
61