Table of Contents
Advertisement
lid covering the compartment. DO NOT use the FAVOR AIR if you detect any moisture
or water inside.
CAUTION!
- do not use compressed air to blow water off the unit
- do not use solvents or other cleaning fluids that might cause damage
- do not test or use the FAVOR AIR in pressurized air.
5.2
ASSEMBLY AND DISASSEMBLY
The FAVOR AIR can be disassembled. This needs to be done partly or completely
when:
- adding or removing the compass unit
- cleaning or replacing the display shield
- cleaning the unit thoroughly
- replacing the regulator hose
- replacing the battery.
Compass Unit, Display Shield or Replacement of the Battery
1.
Unscrew the two screws at the bottom of the unit.
2.
Pull out the crossbar.
3.
Remove or install the display shield, the compass module or the rear cover for
battery replacement (see chapter 5.3 for battery replacement).
4.
Refit the crossbar.
5.
Fasten the two screws.
Compass Module
The compass module itself is mounted very tightly into the boot and it should preferably
not be removed. If necessary, bring the console to an authorized dealer.
Computer Removal
This needs to be done for cleaning the inside of the console or for replacing the hose:
1.
Remove the crossbar as described above.
2.
Pull out the compass module, if fitted.
3.
Lift out the display shield.
4.
Open the rear cover.
5.
Carefully remove the computer by pressing at the top edge of the front side of the
FAVOR AIR. DO NOT press on the LCD display itself (see chapter 5.1 for
cleaning the console).
6.
Reassemble the FAVOR AIR by carrying out the above steps in reverse order.
30
Hide quick links:
Advertisement
Table of Contents
