Table of Contents
Advertisement
14
Higher personal/altitude adjustment modes will shorten the no-decompression time
limits. These limits for different personal/altitude adjustment mode selections are shown
in Tables 6.1 and 6.2 in Section 6.1, "Operating Principles".
Dive Numbering Shown During Dive Planning
Several repetitive dives are considered to belong to the same repetitive dive series
when the FAVOR AIR has not deactivated itself. The first dive of the series will be
numbered as DIVE 1, the second as DIVE 2, the third as DIVE 3 etc.
When the surface time has been less than 10 minutes, the dives are considered to be
the same. The dive number will not change for the second part of such a dive and the
dive time will start where it left off.
3.3.3 Calendar Clock Function
The calendar clock is always shown on the display when the FAVOR AIR is deactivated.
In this mode the power consumption of the FAVOR AIR is minimal.
Once the FAVOR AIR is activated the TIME display can be retrieved any time on the
surface by touching the TIME/MODE and COM contacts for about two seconds. When
diving, the TIME display can be retrieved by pressing the tap switch twice. The current
time and date will be shown for four seconds.
When diving, the dive entry time and date is registered in the logbook memory.
Remember always to check before diving that the clock is set, especially when traveling
to different time zones. For adjusting the clock, refer to Section 4.4, "Setting Time and
Date".
In the metric version of the FAVOR AIR, the 24-hour time system is used, while in the
imperial version the 12-hour time system is used.
3.4 DIVING
3.4.1 Basic Dive Data
The FAVOR AIR will remain in the SURFACE mode at depths less than 1.8 m [6 ft]. At
depths greater than 1.8 m the FAVOR AIR will go into the DIVE mode.
Each piece of information on the display is clearly marked. During a no-decompression
dive, the following information will be shown:
Hide quick links:
Advertisement
Table of Contents
